EciAdsl on Archlinux 0.8 - pacman closes connection

[ErMoviola]

Hi all,

I'm using ArchLinux 0.8 and I've installed the eciadsl driver 0.11 from source (patched to be used with 2.6.20 kernel).
If I try to coonect using eciadsl-start it goes fine, I get connected and I can ping any site or ip address. But if try to use pacman -Sy or wget the modem gets disconnected and powers off and after a while it powers on again, without reconnecting.

Anyone knows what could it be?

Thanks

ErMo

[FlashCode]

You should try other synch .bin files. Depending on .bin file, connection may be more stable.

[ErMoviola]

I've been using other distros before (Suse, *ubuntu) and the synch .bin file was always the same. Does it change depending on which distro I use?

Anyway, I'll try.

ErMo

[FlashCode]

Hard to answer to this question, we still don't know anything about synch protocol
So I can't say why a .bin will be better than another, and sometimes you have to change .bin for unknown reasons....