64Bit Ubuntu 110.4 and D-Link DSL-200

[twinturbo]

Hi Guys and Gals.

I am having a few issues trying to get a d-link DSL-200 B1 working with eciadsl.

The system is ubuntu 11.04
1) I am installing on 64Bit and get an architecture warning when I try to install the package. I force this and --force-architecture and it seems happier - but..

2) it complains about dependancies for bash, ppp and libc6 . I have checked but hey seem to be installed and up to date???

3) it does not unpack the drivers correctly, leaving them with the wrong name in the etc/eciadsl folder ( save for providers etc )

I have gone through the setup and tried runnign eciadsl-start but get this output.

=====================================================
[EciAdsl 1/5] Setting up USB support...

Preliminary USB device filesystem is missing... trying to mount
Preliminary USB device filesystem: failed to load
/usr/bin/eciadsl-start: line 263: fatal: command not found
cat: /proc/bus/usb/devices: No such file or directory
Warning: tun/tap module does not exist

[EciAdsl 2/5] Uploading firmware...

grep: /proc/bus/usb/devices: No such file or directory
grep: /proc/bus/usb/devices: No such file or directory
ERROR: modem not found
=================================================


lsusb shows

[EciAdsl 1/5] Setting up USB support...

Preliminary USB device filesystem is missing... trying to mount
Preliminary USB device filesystem: failed to load
/usr/bin/eciadsl-start: line 263: fatal: command not found
cat: /proc/bus/usb/devices: No such file or directory
Warning: tun/tap module does not exist

[EciAdsl 2/5] Uploading firmware...

grep: /proc/bus/usb/devices: No such file or directory
grep: /proc/bus/usb/devices: No such file or directory
ERROR: modem not found




lsusb output

==========================================================
Bus 002 Device 008: ID 0915:8102 GlobeSpan, Inc. DSL-200 ADSL Modem
Bus 002 Device 003: ID 058f:9360 Alcor Micro Corp. 8-in-1 Media Card Reader
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub



Config is
========================================
VID1=0915
PID1=8102
VID2=0915
PID2=8102
MODE=VCM_RFC1483_ROUTED_IP
VCI=38
VPI=0
FIRMWARE=/etc/eciadsl/firmware00.bin
SYNCH=/etc/eciadsl/gs7470_synch20.bin
PPPD_USER=not what's printed
PPPD_PASSWD=
USE_DHCP=yes
USE_STATICIP=no
STATICIP=
GATEWAY=
MODEM=D-Link DSL200 rev B
MODEM_CHIPSET=GS7470
SYNCH_ALTIFACE=5
PPPOECI_ALTIFACE=1
PROVIDER=UK..Pipex UK
DNS1=62.241.162.200
DNS2=62.241.162.200




Any clues on what I am doing wrong..

Cheers

TT